Finance & Levies

Average Strata Fees in Sydney, Melbourne, Brisbane and Other Cities: What the Data Shows

Most 'average strata fee' pages invent their numbers. No government collects levy data. Here is the published data that does exist, by city, with its source, date and sample, and how to tell whether your own levy is high.

By Buddy · · 13 min read

On this pageThe owner briefing
  1. The owner briefing
  2. Quick answers
  3. What are the average strata fees in Sydney?
  4. How much are body corporate fees in Brisbane and the Gold Coast?
  5. What are average owners corporation fees in Melbourne?
  6. How much are strata levies per quarter?
  7. How do I know if my strata levy is too high?
  8. Why there is no official average
  9. What the data shows, city by city
  10. What the Microburbs figures measure
  11. What the CHU figures measure
  12. Why levies vary so much
  13. What is inside a levy
  14. What a high or low levy can signal for a buyer
  15. How to compare your own levy properly
  16. The state-by-state picture
  17. Buyer checklist
  18. Committee checklist
  19. How UnitBuddy fits
  20. Related reading
  21. Sources and further reading

The owner briefing

  • No government publishes average strata levies for any Australian city. The Strata Community Association said in 2023 that levy data is not collected at state, territory or national level.
  • Two real datasets come close: a listing-based levy analysis by Microburbs (state level, listings from 2019 to early 2026) and CHU's per-lot strata insurance premiums by city (2025 report).
  • A city average tells you little about one building. Your levy is your building's budget, split by your unit entitlement. Compare it with your own plan before you compare it with a postcode.

Search "average strata fees Sydney" and you get pages of confident numbers with no source, no date and no sample. Some are calculators. Some are guesses dressed as research. I went looking for figures that can be traced to a dataset, and this post publishes only those, with what each one measures.

The short version: the data is thin. Where I could not find a credible city figure, I say so.

Quick answers

What are the average strata fees in Sydney?

Nobody publishes a Sydney-only average. The best traceable figure is state-wide: Microburbs' 2026 analysis of real estate listings found a typical NSW strata levy of $854 a quarter ($3,416 a year), across 24,064 properties in listings from 2019 to early 2026. Agents disclosed those amounts. They are not levy notices, and older listings understate today's levies. CHU's 2025 market report puts the average Sydney strata insurance premium at $1,176 per lot a year. The city table has the detail.

How much are body corporate fees in Brisbane and the Gold Coast?

Microburbs' 2026 listing analysis found a typical Queensland levy of $800 a quarter across 11,514 properties. It does not split Brisbane from the Gold Coast. Insurance does differ. CHU's 2025 report puts the average strata premium at $995 per lot a year in Brisbane and $1,403 on the Gold Coast, the highest of the seven cities it lists.

What are average owners corporation fees in Melbourne?

There is no reliable Melbourne figure. Microburbs' 2026 analysis reports a typical Victorian levy of $612 a quarter, but marks Victoria as "low coverage": 1,257 properties, about 3 per cent of its sample. I would not rely on it. CHU's 2025 report puts Melbourne's average strata insurance premium at $920 per lot a year.

How much are strata levies per quarter?

It depends far more on the building than the city. In Microburbs' 2026 analysis, buildings with no amenities mentioned in listings had a typical levy of $760 a quarter. Buildings with a lift were at $1,230 and buildings with a concierge at $1,267. A walk-up and a tower in the same suburb are different products.

How do I know if my strata levy is too high?

Compare the building with itself first. Split the levy into the admin fund and the capital works (or sinking) fund, divide each by the number of lots, and check the long-term contribution against what the building's plan recommends. Our levy benchmarking method walks through six numbers that answer the question better than any city average.

Why there is no official average

Strata levies are set by each scheme at its annual general meeting. No state regulator collects them. When the Strata Community Association answered media questions about rising levies in December 2023, it said full levy data "is not captured at a state, territory or national level".

Western Australia comes closest to official data, and it measures something else. Landgate collects annual returns from strata managers. Its 2025 results, published in 2026, cover 121 returns, 10,210 schemes and 154,224 lots for calendar year 2025. Managers held $6,330 per lot on average across admin and reserve funds. That is money in the bank at a point in time, not what owners pay each quarter. It also leaves out self-managed schemes.

NSW now collects annual reports from every scheme through Strata Hub. I found no published aggregate levy figures from it as at November 2026.

So any page quoting "the average strata levy in Sydney" to the dollar should tell you where the number came from. If it doesn't, assume it came from nowhere.

What the data shows, city by city

Two datasets can be traced to a method. Neither is a city levy average, so read the notes.

CityTypical total levy (state figure, Microburbs 2026)Average strata insurance per lot per year (CHU, 2025 report)Note
SydneyNSW: $854 a quarter (24,064 properties)$1,176Largest sample. Still state-wide, not Sydney only.
MelbourneVic: $612 a quarter (1,257 properties)$920Microburbs flags low coverage. Treat the levy figure as unreliable.
BrisbaneQld: $800 a quarter (11,514 properties)$995Levy figure is Queensland-wide.
Gold CoastQld: $800 a quarter (same figure)$1,403Highest insurance of CHU's seven cities. No separate levy figure.
PerthWA: $634 a quarter (6,837 properties)$1,085Levy figure is WA-wide.
AdelaideSA: $288 a quarter (2,419 properties)$842Lowest levy figure of the eight states. The data doesn't say why.
HobartTas: $375 a quarter (309 properties)$765Microburbs flags a small sample.
CanberraACT: $752 a quarter (1,634 properties)Not reportedCHU's city table does not include Canberra.
DarwinNT: $1,269 a quarter (1,200 properties)Not reportedMicroburbs flags a small sample. No per-lot insurance figure found.

What the Microburbs figures measure

Microburbs' strata levy whitepaper (Luke Metcalfe, Microburbs Research, 2026) extracted levy amounts from 6.8 million listing descriptions. It kept a high-confidence set of 49,234 properties in 19,270 buildings, and published a building only when separate listings agreed within 10 per cent. Read these limits before you quote it:

  • The amounts are what agents wrote in listings, not levy notices. Microburbs checked accuracy against its own extractions, not against real notices.
  • Listings run from 2019 to early 2026. Microburbs says older listings may understate current levies.
  • It calls the figure a "typical" levy without saying whether that is a median or an average.
  • It does not split the admin fund from the capital works or sinking fund, and it does not say whether special levies are included.
  • Results are by state, not city. Sydney is mixed with regional NSW, Brisbane with the Gold Coast.

What the CHU figures measure

CHU is a strata insurance underwriting agency. Its 2025 State of the Strata Market report (dated October 2025) lists the average strata insurance premium for seven cities, sourced to "CHU internal data". The same report says the national average rose 2.8 per cent in the twelve months to June 2025, from $954 to $981 per lot a year.

These are one insurer's book, not the whole market. They are useful because insurance sits inside your admin fund levy, and they show the city spread clearly: in CHU's figures a Gold Coast lot pays $1,403 a year and an Adelaide lot $842.

For Darwin, the ACCC reports on northern Australia insurance by region and per $100,000 sum insured, not per lot. In July 2025 it reported a 7 per cent fall in the average strata premium per $100,000 sum insured in medium-to-high cyclone risk regions after the cyclone reinsurance pool began. I found no per-lot figure for Darwin.

Why levies vary so much

A levy is a building's annual budget divided among its lots. The budget is what moves.

Lifts, pools and concierge. In Microburbs' 2026 data, buildings whose listings mentioned no amenities had a typical levy of $760 a quarter. Buildings with a pool were at $1,129, a gym $1,194, a lift $1,230 and a concierge $1,267. These overlap: a building with a concierge usually has a lift too, so don't add them up.

Insurance. Building insurance is usually one of the biggest lines in the admin fund. CHU's 2025 city figures run from $765 per lot a year in Hobart to $1,403 on the Gold Coast. Within a city, cladding, claims history, flood or cyclone exposure and an out-of-date sum insured move the premium further.

Building age and defects. An older building is closer to its big replacements: roof, lifts, facade, waterproofing. A newer building may be paying for defect investigations or repairs. Either can push up the capital works contribution or bring a special levy.

Capital works fund health. Two similar buildings can charge very different levies because one has saved and one hasn't. The low-levy building is often the one that will need a special levy.

Unit entitlement. Your share of the budget is not an equal split. In NSW, the levy each owner pays is based on unit entitlement, according to NSW Fair Trading and of the . In Victoria, annual fees follow lot liability, according to Consumer Affairs Victoria. In Queensland, contributions follow the contribution schedule, but building insurance in a building format plan follows the interest schedule, according to the Queensland Government. A penthouse and a studio in the same tower can pay very different amounts. If you want to understand your share, read our guide to unit entitlements and levies.

What is inside a levy

Most levy notices have two lines. The names change by state.

  • The admin fund pays this year's running costs: insurance, management fees, cleaning, gardening, common-area power and water, fire and lift servicing, and routine repairs.
  • The long-term fund saves for big works. NSW calls it the capital works fund, Queensland, SA, Tasmania, the ACT and the NT a sinking fund, WA a reserve fund and Victoria a maintenance fund.
  • Special levies sit outside both. They are raised when the funds can't cover a cost.

The rules for the long-term fund differ more than most buyers expect. NSW schemes must have a 10-year plan of major works paid from the capital works fund, reviewed at least every five years, according to NSW Fair Trading (see ). In WA, strata companies with 10 or more lots, or a replacement value of $5 million or more, must keep a reserve fund and a 10-year plan, according to Landgate. In Victoria, an owners corporation needs a maintenance fund only if it has a maintenance plan, and it decides how much of the annual fees goes into it, according to Consumer Affairs Victoria.

That last point matters when you compare cities. A Victorian levy can include little or no long-term saving, so a lower number may just mean less is being put aside. Our admin fund vs sinking fund guide covers what each fund pays for in each state.

What a high or low levy can signal for a buyer

A levy is a price, and price on its own says little. Read it with the building's records.

A high levy can mean:

  • the building has a lift, pool, gym or concierge, and you are paying to run them
  • insurance is high because of location, cladding or claims
  • the committee is catching up after years of underfunding, which is painful but honest
  • a defect or remediation project is being paid for over time.

A low levy can mean:

  • a small walk-up with little to run, which is a genuine saving
  • a capital works fund that is behind its plan
  • deferred maintenance that will come back as a special levy
  • a scheme in a state where the long-term fund is optional, so nothing is being saved.

If I had to pick one figure to check before buying, it would be the gap between what the long-term plan recommends and what the AGM actually levied. A low levy with a fund behind its plan is not cheap. It is a special levy that hasn't been sent yet.

How to compare your own levy properly

City averages can't answer "is my levy high?". These steps can.

  1. Split the levy by fund. Take the annual admin and long-term contributions for the whole building and divide each by the number of lots. You now have two per-lot figures instead of one quarterly bill.
  2. Check your share. Divide your own levy by your unit entitlement (or lot liability) to see whether you are paying your share, no more.
  3. Compare plan with levy. Put the recommended contribution in the capital works plan or sinking fund forecast next to what the AGM struck. A gap that repeats every year is the number that matters most.
  4. Check insurance per lot. Divide the premium by the number of lots. CHU's 2025 city figures give you a rough reference, as long as you remember they come from one insurer's book.
  5. Find buildings you can verify. Two or three buildings in your suburb of similar age, size and amenities, where you can see a strata report or speak to a committee member, are worth more than any website average.

Our benchmarking guide sets out the full six-number method with a worked example. If your levy has jumped, the rising costs of strata living covers the usual causes, and strata vs house running costs puts the levy beside what a house owner pays for the same things.

The state-by-state picture

The same levy questions apply everywhere. The fund names, the way your share is set and the data available differ.

StateLong-term fundHow your share is setLevy data I could findLaw
NSWCapital works fund, 10-year planUnit entitlement ()Microburbs state figure. No published Strata Hub levy data.
VicMaintenance fund, only if there is a maintenance planLot liabilityMicroburbs state figure, low coverage
QldSinking fundContribution schedule; insurance by interest schedule in building format plansMicroburbs state figure
WAReserve fund, 10-year plan for 10+ lots or $5m+ replacement valueCheck the ActMicroburbs state figure; Landgate fund balances held by strata managers
SASinking fundCheck the ActMicroburbs state figure;
TasCheck the ActCheck the ActMicroburbs state figure, small sample
ACTSinking fundCheck the ActMicroburbs state figure
NTSinking fundCheck the ActMicroburbs state figure, small sample

Where the table says "check the Act", I could not confirm the rule from an official source for this post. The fund names come from our admin fund vs sinking fund guide.

Buyer checklist

Our strata report red flags guide covers what else to look for in the report.

Committee checklist

How UnitBuddy fits

UnitBuddy keeps your building's financial record in one place: budgets, transactions, the admin and capital works fund views, and the ten-year capital works plan. Committees can put the plan's recommended contribution next to the levy actually struck, and owners see the same figures in their own view. It does not hold or move money, and it is not trust accounting software.

We can't tell you what the building down the road pays. Nobody reliably can. We can make sure your own building's numbers are ready when someone asks whether the levy is high.

Sources and further reading

What changed in strata this month? Read the strata news for your state, with every figure sourced.

More guides like this